Meshopia · EnglishEnglish
MESHOPIA

8 modelos publicados

Electrónica

Explora modelos 3D de electrónica publicados en Meshopia. Compara material, tecnología, dificultad y licencia antes de imprimir.Open all filters →
Vista de Brazo de recambio para servomotor MG995

Replacement arm for MG995 servomotor

Printable arm or horn to replace the output attachment of an MG995 servomotor. It is a coupling piece between the servo shaft and the mechanism to be moved; it does not include the servomotor or the control rod. The compatibility indicated by the source is limited to the MG995 and must be verified with the specific unit, especially regarding the central splining and the fastening. Preparation, compatibility, and printing The author suggests a 50% infill. This data does not certify the strength of a particular print. Before assembling, check that the splining fits without force, that the screw holds the piece, and that the arm does not rub during the entire range of motion. Prepare a fit test first and avoid compensating for an incorrect fit by tightening the screw further.

Technology
Sin probar
material
—
Difficulty
Sin especificar
Vista de Palanca para mando Xbox y simulador de drones

Lever for Xbox controller and drone simulator

Accessory placed over an Xbox controller stick to use it as a lever in a drone simulator. Its function is to modify the grip of the controller during the simulation; it does not convert the controller into a radio control transmitter nor does it add direct communication with a drone. The source does not identify all compatible controller revisions. Preparation, compatibility, and printing The author specifies PLA and supports. Compare the housing with your controller's stick and check that the accessory does not press buttons or limit the range of motion. Carefully remove the supports in the engagement areas. Start with a fit test without forcing the stick; then configure sensitivity and calibration within the simulator.

Technology
Sin probar
material
PLA
Difficulty
Sin especificar
Vista de Pieza de sujeción del conector de batería para Air65

Battery connector mounting piece for Air65

Replacement plastic part for the connector area of a battery used in an Air65. The author developed it after breaking the original part during an intervention. The publication does not identify the exact battery nor provide an electrical repair procedure, so it is not presented as a universal spare part nor as an instruction for opening a cell. Preparation, compatibility, and printing Check the connector geometry and the available space with the equipment disconnected. The print must not compress the battery, expose contacts, or replace damaged insulation. No material or printing parameters are specified. If the battery is damaged, the printed part does not make it safe or suitable for continued use.

Technology
Sin probar
material
—
Difficulty
Sin especificar