Meshopia · EnglishEnglish
MESHOPIA

5 modelos publicados

Juguetes y juegos

Explora modelos 3D de juguetes y juegos publicados en Meshopia. Compara material, tecnología, dificultad y licencia antes de imprimir.Open all filters →
Vista de Separadores de llanta para DKS Pro de DukeDoks

Wheel spacers for DukeDoks DKS Pro

Spacers designed to prevent certain commercial wheels from rubbing against the suspension arms of the DukeDoks DKS Pro. The source offers thicknesses of 1, 2, 3, 4, and 5.5 mm. The fit depends on the wheel, the tire, and the actual configuration; adding spacing also modifies the wheel's position relative to the axle. Preparation, compatibility, and printing The author relates 1 mm to M3 × 16 screw, 2 and 3 mm to M3 × 18, 4 mm to M3 × 20, and 5.5 mm to M3 × 25. Check that the chosen length reaches the nut without bottoming out. Use PLA and perimeters until the section is filled. Before riding, rotate and articulate each wheel to confirm that the rubbing disappears without creating another point of contact.

Technology
Sin probar
material
—
Difficulty
Sin especificar
Vista de Tapa de batería de repuesto para Nerf Terrascout

Replacement battery cover for Nerf Terrascout

This cover is intended as a replacement for the battery compartment of a Nerf Terrascout. The author created it to replace a missing cover, as no other was available. The render allows for the identification of the closing body, its edges, and the fastening elements integrated into the geometry. The download corresponds to the printed part; it does not include the battery, hardware, or the toy shown as context. Its purpose is to restore the compartment closure, but the model name does not substitute a fit test. Before printing, compare the support and fastening areas with your unit and check that there is no damage to the original housing. No compatible variants or guaranteed tolerances are documented. As a preparation tip, check the flatness of the cover and the overhangs of the tabs in the slicer. Select an orientation that allows these details to be reproduced and the supports to be removed without damaging them. Check the fit with the equipment turned off and without forcing the closure. The source does not specify material, layer height, infill, or tested mechanical strength; these settings must be verified for your specific printer and use case.

Technology
Sin probar
material
—
Difficulty
Sin especificar