Meshopia · EnglishEnglish
MESHOPIA

4 modelos etiquetados

#tpu

Descubre modelos 3D etiquetados como tpu y revisa sus datos de impresión, archivos y condiciones de uso antes de descargarlos.Open all filters →
Vista de Tapón de escape para motor DLE de 120 cc

Exhaust plug for 120 cc DLE engine

Flexible plug intended for the exhaust of a 120 cc DLE model aviation engine. The source identifies it as a closure for the exhausts and documents a print in TPU with a 10% infill. It does not specify the exact diameter of the exhaust nor does it certify resistance to operating temperature. Preparation, compatibility, and printing Check the fit with the engine stopped and completely cool. When preparing the print, check that the slicer reproduces the walls and the closure without gaps. The TPU and the percentage mentioned come from the author and must be adapted to the filament and the printer. Remove any storage plug before starting the engine; it is not presented as a component to obstruct an exhaust in operation.

Technology
Sin probar
material
TPU
Difficulty
Sin especificar
Vista de Carcasa Flywoo O4 adaptada para cámara CO3

Flywoo O4 housing adapted for CO3 camera

Housing modified from the Flywoo O4 design to house a CO3 camera. The source indicates a 25.4 × 25.4 mm mounting pattern and mentions M2 screws and threaded inserts. The modification adds material around the camera; the author's claims regarding impacts or vibrations do not equate to protection tested by Meshopia. Preparation, compatibility, and printing The author recommends TPU with supports. Check the removal of those supports and the lens clearance before slicing. Verify the exact camera, the connectors, and the clamp closure without tightening the equipment housing. The length of all screws and a confirmed final weight are not provided; measure the assembly before installing it.

Technology
Sin probar
material
TPU
Difficulty
Sin especificar
Vista de Low Profile Screw-on 1/10 RC hex covers

Low Profile Screw-on 1/10 RC hex covers

A set of three different nut covers designed for 1/10 scale RC vehicles to prevent losing nuts on carpet tracks. The author recommends printing these in TPU (specifically mentioning SainSmart) and notes that while the prints are not pre-threaded, the TPU will self-tap onto the axle threads. Included models: - long pro - hex cover: Designed for 2WD rear axles that extend several millimeters past the nut. These are intended to screw onto the axle threads over a low profile nut. The author states they are strong enough to hold the car by. - medium pro - hex cover: Designed for axles with 1-2mm poking out (e.g., B84 rear on 7mm hex or B7 front). Designed for low profile nuts; they provide a slight screw-on effect. - low pro - hex cover: A flat cap that does not screw on. Designed for scenarios where the nut protrudes but the axle is buried (e.g., wheeler front). These are slightly smaller than the nut head to allow for TPU stretch. Author's Note: To improve retention, the author suggests placing the covers 'flats to points' on the nut so they do not line up with the nut's flat sides.

Technology
Sin probar
material
—
Difficulty
Sin especificar
Vista de RC Truck/Car Body Pins Tether

RC Truck/Car Body Pins Tether

TPU filament tethers designed to prevent the loss of body clips during RC vehicle rollovers. To use, create a small hole in the RC body and insert the tether. The author recommends making the hole a couple of sizes smaller than the nub that goes through the body to ensure a tight fit and prevent it from pulling out.

Technology
Sin probar
material
—
Difficulty
Sin especificar