Meshopia · EnglishEnglish
MESHOPIAScale modelling & RC

2 tagged models · Page 1 of 1

#skid

Discover 3D models tagged skid and check their print information, files and terms before downloading.Search this tag in the catalogue →
Vista de Patín de techo para Hobby Plus CR18P Evo Pro

Roof skid for Hobby Plus CR18P Evo Pro

Skid designed to be placed on the roof of the Hobby Plus CR18P Evo Pro. It is a specific body accessory intended for the upper area of the crawler. The source does not detail the fastening method nor certify structural protection or rollover resistance; its nominal compatibility does not replace verification with the actual body. Preparation, compatibility, and printing Place the model on the roof and check supports, holes, and clearances before printing the final version. Pay attention to thin areas that could be damaged when removing supports. No material, layer, or infill are documented. Choose the finish and orientation according to the geometry, without altering the mounting points to fit them by pressure.

Technology
Sin probar
material
—
Difficulty
Sin especificar
Vista de RC helicopter skid clamp

RC helicopter skid clamp

HeliGrip RC helicopter skid clamps are designed for the secure transport and storage of RC helicopters. These clamps lock onto the helicopter's landing skids to provide stability during travel or while organizing a hangar. 1. Purpose: The system is intended to secure helicopter landing skids for safer transport and organized storage. 2. Practical Uses: They can be used to lock a helicopter in place while hitting the road or when storing equipment in a hangar. 3. Included Parts: The model files include various clamp components: RC helicopter skid clamp bottom short, Rc helicopter skid mount double bottom v1, RC helicopter skid clamp bottom, RC heilcopter skid clamp Bottom TPU insert, and RC helicopter skid clamp top TPU insert. 4. Printing and Assembly Guidance: The author suggests printing the main clamps in solid PLA, though ABS or PETG are recommended if heat resistance is needed for use inside a hot vehicle. The TPU inserts should be printed with 0.8mm top and bottom layers and 0.8mm outer walls. To complete the assembly, M4X12 or longer bolts are required.

Technology
Sin probar
material
—
Difficulty
Sin especificar