Meshopia · EnglishEnglish
MESHOPIA

3 modelos etiquetados

#battery

Descubre modelos 3D etiquetados como battery y revisa sus datos de impresión, archivos y condiciones de uso antes de descargarlos.Open all filters →
Vista de Placa de batería de fondo plano para Tamiya Monster Beetle 2015

Flat-bottom battery plate for Tamiya Monster Beetle 2015

Side closure plate for the Tamiya Monster Beetle battery housing, 2015 re-edition. The author replaced the ribbed inner face with a flat surface to accommodate their battery, which was about 4 mm longer than the space available with the original plates. This measurement describes their specific case and does not guarantee an identical expansion in other units. Preparation, compatibility, and printing The source suggests PETG or PLA and considers increasing the infill to 100% around the holes. Check the length and width of your battery before printing and ensure that the plate or screws do not press against the casing. Check the closure and cable routing with the equipment turned off; do not force a battery that is still too large.

Technology
Sin probar
material
PETG, PLA
Difficulty
Sin especificar
Vista de Soporte de batería sobre el eje delantero para crawler Hornet

Battery mount on the front axle for Hornet crawler

Mount to place the battery on the front axle of the competition-style Hornet crawler based on CyberBrick. The author indicates that it requires their modified axle, which they call the "wild axle" in the description. It should not be assumed compatible with the standard axle without comparing the parts. Changing the battery position modifies the weight distribution, but does not guarantee a performance improvement on every build. Preparation, compatibility, and printing First identify the axle associated with the design and check the mount's anchor points. Verify steering clearance, articulation, and cables throughout the full range of motion. The housing must hold the battery without compressing it. Battery dimensions, material, and print profile are not specified; those decisions require checking the actual assembly.

Technology
Sin probar
material
—
Difficulty
Sin especificar
Vista de Pieza de sujeción del conector de batería para Air65

Battery connector mounting piece for Air65

Replacement plastic part for the connector area of a battery used in an Air65. The author developed it after breaking the original part during an intervention. The publication does not identify the exact battery nor provide an electrical repair procedure, so it is not presented as a universal spare part nor as an instruction for opening a cell. Preparation, compatibility, and printing Check the connector geometry and the available space with the equipment disconnected. The print must not compress the battery, expose contacts, or replace damaged insulation. No material or printing parameters are specified. If the battery is damaged, the printed part does not make it safe or suitable for continued use.

Technology
Sin probar
material
—
Difficulty
Sin especificar