Meshopia · EnglishEnglish
MESHOPIA

3 modelos etiquetados

#tamiya

Descubre modelos 3D etiquetados como tamiya y revisa sus datos de impresión, archivos y condiciones de uso antes de descargarlos.Open all filters →
Vista de Placa de batería de fondo plano para Tamiya Monster Beetle 2015

Flat-bottom battery plate for Tamiya Monster Beetle 2015

Side closure plate for the Tamiya Monster Beetle battery housing, 2015 re-edition. The author replaced the ribbed inner face with a flat surface to accommodate their battery, which was about 4 mm longer than the space available with the original plates. This measurement describes their specific case and does not guarantee an identical expansion in other units. Preparation, compatibility, and printing The source suggests PETG or PLA and considers increasing the infill to 100% around the holes. Check the length and width of your battery before printing and ensure that the plate or screws do not press against the casing. Check the closure and cable routing with the equipment turned off; do not force a battery that is still too large.

Technology
Sin probar
material
PETG, PLA
Difficulty
Sin especificar
Vista de Soporte de altavoz Visaton FRS 7 S para Tamiya Scania 770S

Visaton FRS 7 S Speaker Mount for Tamiya Scania 770S

Mount to house a Visaton FRS 7 S speaker in the roof module of a Tamiya Scania 770S. The source describes four mounting points for the speaker, a reinforcement frame, and a side exit for wiring. It suggests a layer of foam or a TPU ring between the speaker and the mount to dampen vibrations. The speaker and these auxiliary elements are not part of the printable piece. Preparation, compatibility, and printing The author recommends PETG or ABS, 30–40% infill, and 100% local reinforcement on the screw turrets. Check dimensions and drill holes against the actual speaker and roof; the approximate measurement of 72 mm cited in the source does not replace that check. Assemble the unit before tightening and keep the cable free from pinches. The acoustic improvements described by the author have not been verified here through testing.

Technology
Sin probar
material
PETG, ABS
Difficulty
Sin especificar
Vista de Borbet wheel for M-size RC cars

Borbet wheel for M-size RC cars

A resized Borbet wheel designed to fit M-size RC chassis. The author states it fits chassis such as Tamiya M05, MB01, and HPI Cup Racer, though they note it may fit others that have not been tested. A separate 3D model of a tire for drifting is available at a provided external link.

Technology
Sin probar
material
—
Difficulty
Sin especificar