Meshopia · EnglishEnglish
MESHOPIA

4 modelos etiquetados

#recambio

Descubre modelos 3D etiquetados como recambio y revisa sus datos de impresión, archivos y condiciones de uso antes de descargarlos.Open all filters →
Vista de Brazo de recambio para servomotor MG995

Replacement arm for MG995 servomotor

Printable arm or horn to replace the output attachment of an MG995 servomotor. It is a coupling piece between the servo shaft and the mechanism to be moved; it does not include the servomotor or the control rod. The compatibility indicated by the source is limited to the MG995 and must be verified with the specific unit, especially regarding the central splining and the fastening. Preparation, compatibility, and printing The author suggests a 50% infill. This data does not certify the strength of a particular print. Before assembling, check that the splining fits without force, that the screw holds the piece, and that the arm does not rub during the entire range of motion. Prepare a fit test first and avoid compensating for an incorrect fit by tightening the screw further.

Technology
Sin probar
material
—
Difficulty
Sin especificar
Vista de Placa de batería de fondo plano para Tamiya Monster Beetle 2015

Flat-bottom battery plate for Tamiya Monster Beetle 2015

Side closure plate for the Tamiya Monster Beetle battery housing, 2015 re-edition. The author replaced the ribbed inner face with a flat surface to accommodate their battery, which was about 4 mm longer than the space available with the original plates. This measurement describes their specific case and does not guarantee an identical expansion in other units. Preparation, compatibility, and printing The source suggests PETG or PLA and considers increasing the infill to 100% around the holes. Check the length and width of your battery before printing and ensure that the plate or screws do not press against the casing. Check the closure and cable routing with the equipment turned off; do not force a battery that is still too large.

Technology
Sin probar
material
PETG, PLA
Difficulty
Sin especificar
Vista de Pieza de sujeción del conector de batería para Air65

Battery connector mounting piece for Air65

Replacement plastic part for the connector area of a battery used in an Air65. The author developed it after breaking the original part during an intervention. The publication does not identify the exact battery nor provide an electrical repair procedure, so it is not presented as a universal spare part nor as an instruction for opening a cell. Preparation, compatibility, and printing Check the connector geometry and the available space with the equipment disconnected. The print must not compress the battery, expose contacts, or replace damaged insulation. No material or printing parameters are specified. If the battery is damaged, the printed part does not make it safe or suitable for continued use.

Technology
Sin probar
material
—
Difficulty
Sin especificar
Vista de Tapa de batería de repuesto para Nerf Terrascout

Replacement battery cover for Nerf Terrascout

This cover is intended as a replacement for the battery compartment of a Nerf Terrascout. The author created it to replace a missing cover, as no other was available. The render allows for the identification of the closing body, its edges, and the fastening elements integrated into the geometry. The download corresponds to the printed part; it does not include the battery, hardware, or the toy shown as context. Its purpose is to restore the compartment closure, but the model name does not substitute a fit test. Before printing, compare the support and fastening areas with your unit and check that there is no damage to the original housing. No compatible variants or guaranteed tolerances are documented. As a preparation tip, check the flatness of the cover and the overhangs of the tabs in the slicer. Select an orientation that allows these details to be reproduced and the supports to be removed without damaging them. Check the fit with the equipment turned off and without forcing the closure. The source does not specify material, layer height, infill, or tested mechanical strength; these settings must be verified for your specific printer and use case.

Technology
Sin probar
material
—
Difficulty
Sin especificar