MESHOPIAScale modelling & RC3 tagged models · Page 1 of 1
Purpose This object is a wall hanger designed for the WLtoys 12428 RC car. Practical Uses It is intended to be used as a mounting solution to hang the vehicle on a wall. Included Parts - supportMuralWLToys.stl Note: The author states this object was created in Tinkercad.
Purpose These 10mm hex adapters are designed to allow the use of 10mm hex wheels from the Spanish company Bycmo on other RC models. Practical Uses The adapters are intended for LC-racing or WLtoys vehicles in 1/14 and 1/12 scales. The author notes that 1/10 scale models also use the same 10mm hex size. Included Parts - RC hex10.stl - RC hex10 4ks.gcode Printing Guidance The author recommends using PLA filament with a 0.4mm nozzle. Suggested settings include a nozzle temperature of 210°C, a bed temperature of 45°C, a layer height of 0.2mm, and a first layer height of 0.3mm.
Purpose This redesigned front steering system for the WLtoys A959 is intended to increase the steering angle to improve drift performance. The design removes front traction to allow for more freedom and control during drifts. Practical Uses The system is designed for controlled drifting and smoother transitions. The modification is non-destructive, allowing the vehicle to be returned to its original state without damaging any parts. The author suggests using a gyro for an improved experience. Included Parts - brazo direccion .stl - brazo servo .stl - Drag_link .stl - horquilla .stl - masa.stl - placa direccion inf .stl - placa direccion sup .stl - Servo_Bracket .stl - soporte masa .stl Printing and Assembly Guidance The author reports all parts were printed in PETG. The horquilla (fork) and brazo de direccion (steering arm) must be printed as mirrors. Only the steering arm and servo arm require supports. Required hardware includes 10 M2 screws: 2x M2*20 and 8x M2*8.