Satsana Duct (Ender 3) for Nebula bracket + CR Touch + G sensor
Satsana Duct (Ender3) for Nebula bracket + CR Touch + G sensor Purpose This model is a remix of the original Satsana duct designed specifically for the Ender 3. It is modified to accommodate a CR Touch holder that integrates the vibration sensor from the Nebula Pad. By keeping the CR Touch in its original position, this design eliminates the need to manually set X or Y offsets. Practical Uses This duct is intended for users upgrading an Ender 3 with a Nebula bracket, allowing for the simultaneous use of a CR Touch and a vibration sensor while maintaining standard probe positioning. Included Parts - Satsana_CR_Touch_remix_mymod_v2.stl Printing and Assembly Guidance According to the author, the same printing settings used for the original Satsana model can be applied here. However, small supports are required in specific areas: where the screw is located and where the CR Touch piece is held.
- Tecnología
- Sin probar
- Material
- —
- Dificultad
- Sin especificar