Información del modelo
Descripción
Satsana Duct (Ender3) for Nebula bracket + CR Touch + G sensor
Purpose
This model is a remix of the original Satsana duct designed specifically for the Ender 3. It is modified to accommodate a CR Touch holder that integrates the vibration sensor from the Nebula Pad. By keeping the CR Touch in its original position, this design eliminates the need to manually set X or Y offsets.
Practical Uses
This duct is intended for users upgrading an Ender 3 with a Nebula bracket, allowing for the simultaneous use of a CR Touch and a vibration sensor while maintaining standard probe positioning.
Included Parts
- Satsana_CR_Touch_remix_mymod_v2.stl
Printing and Assembly Guidance
According to the author, the same printing settings used for the original Satsana model can be applied here. However, small supports are required in specific areas: where the screw is located and where the CR Touch piece is held.
Texto original del autor en Printables
<p>This is a Satsana duct remix to fit the crtouch holder that also has the vibración sensor from the nebula pad without the need to set a x or y offset as the cr touch stays as in the original place</p><p> </p><p>Same settings as the original this was remixed from, that is some little supports in the part were the screw goes and where the cr touch piece holds to</p>
Preguntas y aportaciones