CR10 MAX CR touch bracket spacer
This model is a spacer designed to facilitate the installation of a CR Touch sensor when upgrading from a BL Touch sensor on a CR10 MAX. Because the CR Touch sensor is taller than the original BL Touch, this spacer allows for compatibility when the original bracket is flipped upside down, avoiding the need for a completely new bracket. Practical uses include upgrading existing CR10 MAX hardware from BL Touch to CR Touch sensors. Included parts: - cr 10 max bracket.stl Printing and assembly guidance: Printing time is approximately 20 minutes. The author recommends printing this part out of PETG due to its proximity to the hot end. To install, the original bracket must be flipped upside down and this spacer added to accommodate the height of the CR Touch sensor.
- Tecnología
- Sin probar
- Material
- —
- Dificultad
- Sin especificar