Información del modelo
Descripción
This model is a spacer designed to facilitate the installation of a CR Touch sensor when upgrading from a BL Touch sensor on a CR10 MAX. Because the CR Touch sensor is taller than the original BL Touch, this spacer allows for compatibility when the original bracket is flipped upside down, avoiding the need for a completely new bracket.
Practical uses include upgrading existing CR10 MAX hardware from BL Touch to CR Touch sensors.
Included parts
- cr 10 max bracket.stl
Printing and assembly guidance:
Printing time is approximately 20 minutes. The author recommends printing this part out of PETG due to its proximity to the hot end. To install, the original bracket must be flipped upside down and this spacer added to accommodate the height of the CR Touch sensor.
Texto original del autor en Printables
<p>So our BL touch sensor broke, so we got a CR touch sensor, they cost like $40, but it didn't fit, it was taller than the BL touch, so we had to flip the OG bracket upside down, and ad this spacer, it was the only way to put it on there without having to put a new bracket on there. It takes about 20 minutes to print. You want to print it out of PETG because it is next to the hot end.</p><p></p><p>ENJOY, and please post your makes!!!</p>
Preguntas y aportaciones