Meshopia · EnglishEnglish
MESHOPIA

1 modelo etiquetado

#beetle

Descubre modelos 3D etiquetados como beetle y revisa sus datos de impresión, archivos y condiciones de uso antes de descargarlos.Open all filters →
Vista de Placa de batería de fondo plano para Tamiya Monster Beetle 2015

Flat-bottom battery plate for Tamiya Monster Beetle 2015

Side closure plate for the Tamiya Monster Beetle battery housing, 2015 re-edition. The author replaced the ribbed inner face with a flat surface to accommodate their battery, which was about 4 mm longer than the space available with the original plates. This measurement describes their specific case and does not guarantee an identical expansion in other units. Preparation, compatibility, and printing The source suggests PETG or PLA and considers increasing the infill to 100% around the holes. Check the length and width of your battery before printing and ensure that the plate or screws do not press against the casing. Check the closure and cable routing with the equipment turned off; do not force a battery that is still too large.

Technology
Sin probar
material
PETG, PLA
Difficulty
Sin especificar