Meshopia · EspañolEspañol
MESHOPIAModelismo y radiocontrol

2 modelos etiquetados · Página 1 de 1

#torque

Descubre modelos 3D etiquetados como torque y revisa sus datos de impresión, archivos y condiciones de uso antes de descargarlos.Buscar esta etiqueta en el catálogo →
Vista de Open RC Upgrade Wheel Hub 1:8

Open RC Upgrade Wheel Hub 1:8

Open Rc Upgrade wheel HUB 1:8 Purpose This upgraded wheel hub is designed for Open RC users experiencing difficulties caused by powerful motors and high torque. It is intended to hold the axle firmly in place and enable proper wheel torquing. Practical Uses It serves as a replacement or upgrade for standard hubs in 1:8 scale Open RC applications where high torque performance is required to maintain axle stability. Included Parts The model includes the WHEEL HEX NUT.stl file. Assembly Guidance Assembly requires a square M3 nut and M3x6 worm screws. The design utilizes two M3 screws and M3 rectangular nuts to secure the axle.

Tecnología
Sin probar
Material
—
Dificultad
Sin especificar
Vista de Reduction Gears for Robak 2

Reduction Gears for Robak 2

Purpose This modification provides a 19:1 gear reduction for the Robak 2, designed to increase torque while reducing top speed. This setup aims to improve acceleration, climbing capacity, and energy efficiency at low speeds, while reducing motor startup hesitation in sensorless configurations. Practical Uses The gear set is intended for use in the Robak 2 to enhance low-speed performance and climbing capabilities. Included Parts - Sleeve.stl - MotorPlate.stl - Gear1_13T.stl - Gear2_31T.stl - Gear3_14T.stl - Gear4_38T.stl - TopDeckR.stl Assembly Guidance Users must print the updated version of the TopDeck rear. Assembly requires removing a thin piece of plastic from the Chassis using pliers. Required hardware includes various M3 and M4 screws, nuts, a brass standoff, and specific bearings (3x 15x10x4mm and 2x 10x5x4mm).

Tecnología
Sin probar
Material
—
Dificultad
Sin especificar