3 modelos etiquetados · Página 1 de 1

#toolhead

Descubre modelos 3D etiquetados como toolhead y revisa sus datos de impresión, archivos y condiciones de uso antes de descargarlos.Buscar esta etiqueta en el catálogo →

HerramientasGratis

Dragon Burner V8 CR-Touch Shroud

Dragon Burner V8 CR-Touch Shroud Purpose This model provides CR-Touch support for the Dragon Burner V8 toolhead. It is designed to integrate bed leveling capabilities into the existing toolhead setup. Practical Uses It is used to mount a CR-Touch sensor to the Dragon Burner V8 toolhead. The author specifies the following probe offsets for configuration: X=-37.2, Y=10.1. Included Parts - Dragon Burner PFACatBody + Duct.stp.stl - Dragon Burner PFACatBody + Duct.stp Assembly Guidance According to the author, the assembly process for this component is the same as the regular fan shroud.

Tecnología: Sin probar
Material: —
Dificultad: Sin especificar

HerramientasGratis

Manta MK2 CR Touch Mount Center Mount

Manta MK2 CR Touch Mount Center Mount Purpose This model is designed for the Manta MK2 Ender V1/V2 system to allow the CR Touch to be used as the sensor instead of the BLTouch. Practical Uses It serves as a center mount for the CR Touch. When installing, the user suggests using the included spacer to adjust the CR Touch approximately 3mm above the nozzle to prevent crashes or incorrect Z-offset readings. Users may also use the 2mm side of the spacer or flush the CR Touch to the bed, though the 3mm spacing is recommended. Included Parts The files provided include the Manta CR Touch V3 STL and a 3MF file. Printing and Assembly Guidance For printing, the source suggests using PETG, ABS, or stronger materials rather than PLA. If using a high-temperature setup, use high-temperature resistant materials. Recommended print settings include a layer height of 1.6mm or 2.0mm and 100% infill. For ABS and PETG, a speed of 40mm/s is suggested. During assembly, installation involves using washers, screws through the CR Touch and bracket, followed by a washer and a nut. The source notes an X/Y offset of X= -1.8 and Y= -37.5.

Tecnología: Sin probar
Material: —
Dificultad: Sin especificar

HerramientasGratis

Microswiss NG CR Touch Mount

Purpose: This mount is designed to attach a CR Touch probe to a Microswiss NG Toolhead when used on a custom X axis Ender 3 Pro. Practical Uses: To install the mount to the extruder stepper motor, two M3x25 screws and two M3 washers are required to replace the stock screws. Included Parts: - Microswiss NG Cr Touch Mount.3mf - Microswiss NG Cr Touch Mount (heatset insert version).3mf - microswiss ng cr touch mount.step Printing/Assembly Guidance: Print with the flange on the build plate using PETG or ABS for heat resistance. Recommended settings include a 0.2 mm layer height, infill greater than 20%, 3+ perimeters, and 3+ top/bottom layers. While supports are not required, the author notes they may improve the underside finish. The author provides CAD-calculated probe offsets (X: -47.25, Y: -10, Z: 2.110), but notes that Z offset must be manually recalibrated for individual machines and printed parts.

Tecnología: Sin probar
Material: —
Dificultad: Sin especificar