Meshopia · EspañolEspañol
MESHOPIAModelismo y radiocontrol

2 modelos etiquetados · Página 1 de 1

#riser

Descubre modelos 3D etiquetados como riser y revisa sus datos de impresión, archivos y condiciones de uso antes de descargarlos.Buscar esta etiqueta en el catálogo →
Vista de BowHouse RC SVT Big Bore Mount - RISER

BowHouse RC SVT Big Bore Mount - RISER

This model is a riser designed for the BowHouse RC SVT Big Bore mount. According to the author, using the mount alone resulted in a mesh that was too tight, while the official risers sold by BowHouse were too high. This specific version is intended to provide the correct height for stock gearing. The author notes that the height can be adjusted by raising or lowering the part by the required amount to suit specific needs. Practical Uses: This part is used as a spacer or riser for the BowHouse RC SVT Big Bore mount to achieve the correct mesh when using stock gearing. Included Parts: - BowHouseRiser.3mf

Tecnología
Sin probar
Material
—
Dificultad
Sin especificar
Vista de Creality CR Falcon Laser Engraver Cutter 25mm Modular Riser

Creality CR Falcon Laser Engraver Cutter 25mm Modular Riser

Creality CR Falcon Laser Engraver Cutter 25mm Modular Riser Purpose This modular riser is designed to increase the height of the Creality CR Falcon laser engraver/cutter. Each unit provides a 25mm height increase, and the parts are designed to be stackable to achieve higher elevations. Practical Uses These risers allow users to raise the machine without requiring hardware or modifications to the original device. They fit directly over the machine's existing rubber feet and are designed to fit together securely to maintain stability. Included Parts - Creality CR Falcon Riser v1.0.stl - Creality CR Falcon 25mm Riser_v1.0.3mf Printing and Assembly Guidance The author reports successful printing using PLA with 15% infill on a K1C printer. To ensure tight tolerance mating surfaces are not compromised by support structures, it is suggested to print the part on its non-mating edge. The author recommends using a glue stick and suggests adding a brim to the supplied file to improve print success. For installation, simply slip the part over the machine's rubber feet; additional units can be added to the stack to increase height further.

Tecnología
Sin probar
Material
—
Dificultad
Sin especificar