RC F1 Boat With Outboard Mercury Racing 360
A complete RC F1 Powerboat kit including a 70cm F1 hull and a Mercury Racing 360 style outboard engine. The outboard engine is 20cm in height, suitable for hulls above 70cm, and features adjustable trim and height mounting, a gear lubricant hole, and a watercooling system. The author used PLA for the main body and ABS for the motor mounting. The outboard can use a 3670 motor (as used by the author) or motors up to 4076. Outboard Engine Print Settings: - Min print area: 200x140x50mm - Nozzle: 0.4mm - Layer height: 0.15mm (lower is better for high quality) - Perimeters: 5 wall lines - Top/Bottom: 5 - Infill: 30% - Support: No support required; pre-oriented - Material: Author used PLA, and ABS for motor mounting F1 Hull Print Settings: - Min print area: 235x235x230mm - Nozzle: 0.4mm - Layer height: 0.2mm (lower is better for high quality) - Perimeters: 2/3 wall lines - Top/Bottom: 4 - Infill: 15% - Support: Only required for the servo mount General 3D Printing Settings (FDM): - Nozzle: 0.4mm - Layer height: 0.2mm (lower is better for high quality) - Perimeters: 4 wall lines - Top/Bottom: 4 - Infill: 30% - Support: No support BOM (Outboard): - 2x bevel gear shaft 4mm 15t 0.8 - 1x bearing 604zz - 5x bearing 684zz - 4mm 30cm shaft - Rigid couple joint 4x5 (depending on motor) - 4mm drive dog - Propeller up to 50mm (author used 40mm) - Brushless motor up to 4076 (author used 3670 2150kv) - 18x M2.5 heat inserts (2.5IDx3Lx3.5OD) - 18x M2.5x5 screws - 2x M3 x35/40 with nuts (for adjustable trim) - M2x3 self tapping screw (for gear lubricant hole) - 2x push rod connectors for servo rod BOM (Hull): - 16x M3x8mm (battery tray, ESC tray, servo mount, and servo) - 4x M3x25mm with nuts (outboard mount) - 3x M3x40mm with nuts (cover) - Push rod or stainless steel leader fishing wire for servo rod - Electronics used by author: 2x LiPo 2S 5000mAh, Flycolor 150A ESC, 25kg waterproof servo, Dumborc 6ch transmitter
- Technology
- Sin probar
- material
- —
- Difficulty
- Sin especificar