Meshopia · EnglishEnglish
MESHOPIA

4 modelos etiquetados

#montaje

Descubre modelos 3D etiquetados como montaje y revisa sus datos de impresión, archivos y condiciones de uso antes de descargarlos.Open all filters →
Vista de Soporte de servo con alojamiento para conector

Servo bracket with connector housing

Mount for a servomotor that incorporates a zone intended for a female servo cable connector. The design aims to house the servo and organize the cable output. The source does not identify a specific servo model or its dimensions, so compatibility must be verified in the file and with the physical component. Preparation, compatibility, and printing The hardware is described as "832" and "832 × 1 3/4"; this notation needs confirmation before purchasing or forcing screws into the part. Compare the position of the lugs and the cable path, and ensure the connector remains accessible. No material or profile is documented. Perform a fit test without powering the servo and keep the arm's range of motion clear.

Technology
Sin probar
material
—
Difficulty
Sin especificar
Vista de Soporte de motorreductor N20 con fijaciones de 3 mm

N20 gear motor mount with 3 mm fastenings

Mount to house an N20 gear motor and fasten it to a chassis using two 3 mm screw holes. The source suggests its use in small RC cars, rovers, and robotics projects. The part is a mechanical mount; it does not include the motor, screws, or controller. Preparation, compatibility, and printing Compare the outline of the actual motor and the position of its terminals with the housing. Check that the fastening to the chassis does not deform the mount or block the shaft. The slicer must keep the walls around the drill holes continuous. The source does not provide specific materials or parameters; a first test print helps check tolerances before installing the assembly.

Technology
Sin probar
material
—
Difficulty
Sin especificar
Vista de Carcasa Flywoo O4 adaptada para cámara CO3

Flywoo O4 housing adapted for CO3 camera

Housing modified from the Flywoo O4 design to house a CO3 camera. The source indicates a 25.4 × 25.4 mm mounting pattern and mentions M2 screws and threaded inserts. The modification adds material around the camera; the author's claims regarding impacts or vibrations do not equate to protection tested by Meshopia. Preparation, compatibility, and printing The author recommends TPU with supports. Check the removal of those supports and the lens clearance before slicing. Verify the exact camera, the connectors, and the clamp closure without tightening the equipment housing. The length of all screws and a confirmed final weight are not provided; measure the assembly before installing it.

Technology
Sin probar
material
TPU
Difficulty
Sin especificar
Vista de Soporte de antena para bastidor HGLRC MY5

Antenna mount for HGLRC MY5 frame

Identified antenna mount for the HGLRC MY5 frame. The original description does not provide dimensions or a list of compatible antennas and connectors. The source tags mention various FPV systems, but these are not enough to ensure that all fit on the same part. Preparation, compatibility, and printing Compare the mounting points, housing diameter, and connector space with your frame. Check that the coaxial cable is not forced and that the antenna remains outside the path of the propellers. No material or print profile is documented. A fit test allows checking the retention before installing the electronics.

Technology
Sin probar
material
—
Difficulty
Sin especificar