MESHOPIAModelismo y radiocontrol3 modelos etiquetados · Página 1 de 1
This model is a differential holder designed based on the Hyper Go MJX 16207 differential. The design serves as a base that can be modified to accommodate most RC car differentials. 120-300 words when facts suffice, otherwise be concise.
This model is a metal differential housing designed specifically for the WLtoys 144001 RC vehicle. It serves as a reliable upgrade for hobbyists seeking improved performance and longevity for their 144001 model. In practical use, this housing provides a direct-fit replacement or upgrade for the stock differential components. The author specifies that the Wltoys XK 144001 Metal Differential should be used as the differential gear for this setup. Included parts and required hardware: - Metal Differential Housing - Required bearings: MR105ZZ - Required gear: Wltoys XK 144001 Metal Differential Note: This listing is based on the provided source data. Users should refer to the specific hardware requirements mentioned by the author for successful assembly.
This model is a small design produced to test the mechanical performance of FDM 3D printing. It was tested on a 1/8 scale RC vehicle, specifically mounted on the center differential of a Jammin X1 crt truggy. The author reports that the part successfully held up to rotation speeds of 30,000 rpm. Practical Uses The part functions as an impeller fan/air blower for RC vehicles, specifically intended for use on a center differential. Included Parts The model includes the impeller fan (file: 11.014.6V4.STL). For assembly, use two 2.5mm x 4 screws for the clamping collar. Printing and Assembly Guidance According to the author, the following parameters were used for successful results: - Materials: PLA+ or PC-GF - Layer height: 0.16 - Line width: 0.4 - Supports: Use supports during printing.