turbo rc fan
This model is a small design produced to test the mechanical performance of FDM 3D printing. It was tested on a 1/8 scale RC vehicle, specifically mounted on the center differential of a Jammin X1 crt truggy. The author reports that the part successfully held up to rotation speeds of 30,000 rpm. Practical Uses The part functions as an impeller fan/air blower for RC vehicles, specifically intended for use on a center differential. Included Parts The model includes the impeller fan (file: 11.014.6V4.STL). For assembly, use two 2.5mm x 4 screws for the clamping collar. Printing and Assembly Guidance According to the author, the following parameters were used for successful results: - Materials: PLA+ or PC-GF - Layer height: 0.16 - Line width: 0.4 - Supports: Use supports during printing.
- Tecnología
- Sin probar
- Material
- —
- Dificultad
- Sin especificar