Textured Service Ramp for 1:10 RC Drift Cars - STL
Add a small raised wheel support to an RC display or workbench setup. The source photograph shows a pair of matching ramps with straight inclined approaches, a repeating circular surface pattern and an elevated flat section supported by an open frame. The source folder and filename label the design for 1:10 RC drift cars. One STL file is included, renamed 01-textured-rc-service-ramp.stl in English without altering the printable geometry. The two physical ramps in the reference show a possible paired setup; the file inventory does not establish two separately supplied variants. Inspect the STL layout and print additional copies as needed. No car or other track equipment is included. Compare the ramp width, surface features and elevated support with your intended tires and vehicle. Wheel fit, load capacity, traction and print settings have not been physically tested by MESHOPIA. Select material, orientation, walls and supports after reviewing the model in your slicer. No separate hardware or assembly guide is documented in this extracted set. The current cover is an original AI-assisted MESHOPIA photorealistic illustration of the supplied model or its components in a hobby-workshop use or finishing scene. It illustrates a proposed finish and does not document a manufactured, printed, assembled or tested prototype. Consult the downloadable source files for the geometry and included components.
- Technology
- Sin probar
- material
- —
- Difficulty
- Sin especificar