2 tagged models · Page 1 of 1

#1:10 RC

Discover 3D models tagged 1:10 RC and check their print information, files and terms before downloading.Search this tag in the catalogue →

RC & MecánicaFree

Circular-Base Display Stand for 1:10 RC Crawlers - STL and 3MF

Support an RC crawler on a dedicated stand for display or workbench access. The assembled reference shows a circular base, a central upright with reinforcing fins and an upper cross frame with two broad shaped supports. The source folder labels the project for 1:10 RGT crawlers and describes it as height adjustable. Specific vehicle fit and adjustment range have not been verified by MESHOPIA. Three files are included: a lower stand part in STL, an upper stand part in STL, and a 3MF stand project. They have been renamed in English while retaining their original contents. Inspect the upper and lower interfaces before assembly and review the 3MF layout in compatible slicing software. The 3MF is an additional project file, rather than a third separately named STL component. Compare the support shape and spacing with your crawler chassis. Choose print material, orientation, walls and supports after checking the model in your slicer. No physical stability test, rated load capacity or tested print profile is documented here. The vehicle and any additional hardware are not supplied. The current cover is an original AI-assisted MESHOPIA photorealistic illustration of the supplied model or its components in a hobby-workshop use or finishing scene. It illustrates a proposed finish and does not document a manufactured, printed, assembled or tested prototype. Consult the downloadable source files for the geometry and included components.

Technology: Sin probar
material: —
Difficulty: Sin especificar

RC & MecánicaFree

Textured Service Ramp for 1:10 RC Drift Cars - STL

Add a small raised wheel support to an RC display or workbench setup. The source photograph shows a pair of matching ramps with straight inclined approaches, a repeating circular surface pattern and an elevated flat section supported by an open frame. The source folder and filename label the design for 1:10 RC drift cars. One STL file is included, renamed 01-textured-rc-service-ramp.stl in English without altering the printable geometry. The two physical ramps in the reference show a possible paired setup; the file inventory does not establish two separately supplied variants. Inspect the STL layout and print additional copies as needed. No car or other track equipment is included. Compare the ramp width, surface features and elevated support with your intended tires and vehicle. Wheel fit, load capacity, traction and print settings have not been physically tested by MESHOPIA. Select material, orientation, walls and supports after reviewing the model in your slicer. No separate hardware or assembly guide is documented in this extracted set. The current cover is an original AI-assisted MESHOPIA photorealistic illustration of the supplied model or its components in a hobby-workshop use or finishing scene. It illustrates a proposed finish and does not document a manufactured, printed, assembled or tested prototype. Consult the downloadable source files for the geometry and included components.

Technology: Sin probar
material: —
Difficulty: Sin especificar