Textured Service Ramp for 1:10 RC Drift Cars - STL
Add a small raised wheel support to an RC display or workbench setup. The source photograph shows a pair of matching ramps with straight inclined approaches, a repeating circular surface pattern and an elevated flat section supported by an open frame. The source folder and filename label the design for 1:10 RC drift cars. One STL file is included, renamed 01-textured-rc-service-ramp.stl in English without altering the printable geometry. The two physical ramps in the reference show a possible paired setup; the file inventory does not establish two separately supplied variants. Inspect the STL layout and print additional copies as needed. No car or other track equipment is included. Compare the ramp width, surface features and elevated support with your intended tires and vehicle. Wheel fit, load capacity, traction and print settings have not been physically tested by MESHOPIA. Select material, orientation, walls and supports after reviewing the model in your slicer. No separate hardware or assembly guide is documented in this extracted set. The MESHOPIA cover is a studio render of the actual STL geometry, showing one ramp with its circular surface features, recessed rear platform and open supports. The supplied geometry is unchanged; the new finish, lighting and background are part of the visualization.
- Technology
- Sin probar
- material
- —
- Difficulty
- Sin especificar