Meshopia · EspañolEspañol
MESHOPIAModelismo y radiocontrol

2 modelos etiquetados · Página 1 de 1

#ravine

Descubre modelos 3D etiquetados como ravine y revisa sus datos de impresión, archivos y condiciones de uso antes de descargarlos.Buscar esta etiqueta en el catálogo →
Vista de Front Ravine 25KG servo arm

Front Ravine 25KG servo arm

This model is a redesigned servo arm specifically for a 25kg servo upgrade on the FTX Ravine. Purpose The arm is designed to accommodate a 25kg servo located at the front of the Ravine. Because the servo has been flipped in this configuration, the arm is designed with a shorter profile to suit the specific orientation. Practical Uses To allow for a full range of motion, the arm is designed to stand off from the steering arm by a significant distance. This clearance helps prevent mechanical interference during steering maneuvers. Included Parts The files provided include: - ravine front steer arm.3mf - rev1.2.step Attribution: danchee

Tecnología
Sin probar
Material
—
Dificultad
Sin especificar
Vista de RC FXT Ravine Damper Mount Extension

RC FXT Ravine Damper Mount Extension

RC FXT Ravine Damper Mount Extension Purpose These mounts are designed to raise ground clearance by approximately 10mm and allow for maximum axle articulation on both sides, exceeding 90 degrees. The author states they should also work on the Danchee Ridgerock and Pirate Swinger. Practical Uses They are used to increase vehicle clearance and improve suspension movement. For installation, the author notes you will need to remove the wheels and steering pivot screws to replace the lower screws more easily. Included Parts The set includes four damper mount extensions. Printing and Assembly Guidance Printing settings recommended by the author are 0.1mm layers and 100% infill for strength. Temperature settings suggested are 220°C for filament, 70°C for the first layer, and 50°C for the remainder. The author used a raft and supports everywhere, noting that significant cleaning is required afterward. Technical Specifications The lower holes are 3.3mm and the top holes for the damper swivel are 2.1mm. The author notes that stock damper swivels require a 2.5mm screw. For the lower holes, the author suggests using longer screws, such as 2.5 x 20mm self-tapping screws. The author cautions that PLA is more brittle than original injection-moulded plastic and advises care when screwing into the top holes.

Tecnología
Sin probar
Material
—
Dificultad
Sin especificar