4 modelos etiquetados
Front and rear cockpit boards for the Sebart Avanti XS. These are intended as a replacement for the original wooden boards. Designed for use with JETI Rex10 and RCSW, including Unilight adapter components. The author states these are printed in PLA.
A replacement steering arm designed for an RC snowmobile. The author recommends printing with 100% infill using PLA filament. Printing instructions: use supports, print on a textured bed, set nozzle temperature to 210°C and bed temperature to 60°C.
An alternative pipe load designed for the Turbo Racing 1/76 scale C50 semi truck trailer. This load serves as an alternative to the container or empty trailer options provided by Turbo Racing. Assembly and Printing Instructions: - Print the pipes standing vertically. - A color change can be added for the protective end caps of the pipes. - To match the nose weight supplied with the Turbo Racing box container, drop an M10 steel full nut into the cutout. The author used a small piece of Blue Tack (poster putty) to prevent the nut from rattling. - Attach the pipes to the trailer using a narrow strip of double-sided tape. - The tie-down straps clip into place over the pipe load and trailer bed. - Two strap versions are included: Version 1 is the exact shape, while Version 2 may print neater. If using Version 2, the center section must be cut out using side cutters to match the Version 1 shape. Author's Print Settings/Report: - Material: PLA - Layer height: 0.2 throughout - Perimeters: 2 - Top/Bottom layers: 4 - Infill: 15% - Supports: None - The author used a Prusa Mk3S+ printer.
A tool designed for removing spark plug caps without the use of pliers. It features an M10x1.0 thread on the opposite end, intended for a CM6 spark plug. The author designed this for a 50cc DA engine and notes it should fit several similar engines. The thread includes a 0.3mm offset. The author reports it works well on a Creality Ender 3, but recommends testing and adjusting for your specific printer. The author printed this in PLA with 20% infill and reports it holds up well without breaking.