MESHOPIAModelismo y radiocontrol4 modelos etiquetados · Página 1 de 1
Purpose: This model is a replacement body clip designed for the Exost Pixie RC car. It is intended to hold the vehicle body in place. Practical Uses: It serves as a functional replacement for lost clips on the Exost Pixie RC car. Included Parts: - Exost pixie car clip v1.stl Printing Guidance: The author notes that this small piece printed correctly using a 0.4mm nozzle.
AC Clip for Honda Civic Purpose This clip is designed to address an issue in 2016-2018 Honda Civics where the dashboard AC vents lack the tension to stay in a desired position, causing the flaps to continually tilt upward. The clip locks the driver-side AC vent into a horizontal position. Practical Uses It prevents the vent flaps from tilting up while still allowing them to be temporarily tilted downward. It serves as a quick fix for maintaining vent orientation. Included Parts - civic_clip.stl Printing and Assembly Guidance The author recommends printing in ASA if possible, noting that PLA lacks sufficient temperature resistance for long-term use in hot vehicles, and ABS lacks necessary UV resistance for sun exposure. The author utilized 100% infill to prevent internal pockets of hot air from expanding, though they noted this difference may be negligible due to the small size of the clip. Reference the included pictures in the source to determine the correct placement within the AC vent.
Rc car body clip Purpose This model is a clip designed for use with an RC car body. Practical Uses It serves as a component to secure the body of an RC car in place. Included Parts - Rc car body clip.stl - CE3E3V2_body-clip.gcode Printing Guidance The author specifies printing with a layer height between 0.12mm and 0.20mm. No supports are required for this print.
RC Car Body Clip Retainers Purpose These retainers are designed to hold body clips for RC cars, intended to provide better handling during use. Practical Uses They are used as holders for body clips on RC vehicles, specifically tagged for compatibility with models such as Traxxas and TRX4. Included Parts - Držák spony.stl Printing and Assembly Guidance The author recommends using 100% infill and a 0.2 mm layer height for printing this model.