Meshopia · EspañolEspañol
MESHOPIAModelismo y radiocontrol

3 modelos etiquetados · Página 1 de 1

#axial scx10

Descubre modelos 3D etiquetados como axial scx10 y revisa sus datos de impresión, archivos y condiciones de uso antes de descargarlos.Buscar esta etiqueta en el catálogo →
Vista de Tamiya CR-01 Skid Plate for DIG GearBox (Axial SCX10 compatible)

Tamiya CR-01 Skid Plate for DIG GearBox (Axial SCX10 compatible)

This model is a skid plate designed for the TAMIYA CR-01 to accommodate a DIG GearBox for the Axial SCX10. Its purpose is to facilitate the integration of the DIG GearBox into the CR-01 chassis. Practical uses for this part include upgrading the drivetrain of a TAMIYA CR-01 using Axial SCX10 compatible components. To ensure proper fitment, the user must use a short battery and the battery plate must be cut. The part is compatible with drive shafts measuring 90-110mm for both the front and rear. Included parts: - 1x CR01_skid_DIG.stl Assembly requirements: - 4x M3x10mm bolts - 4x M3 nuts

Tecnología
Sin probar
Material
—
Dificultad
Sin especificar
Vista de Rock Slider SCX10 Jeep Cherokee

Rock Slider SCX10 Jeep Cherokee

Rockslider SCX10 Jeep Cherokee Purpose These rock sliders are designed specifically for the Axial Jeep Cherokee (SCX10). The design features a clamping mechanism that holds the vehicle body within the sliders, allowing for adjustable width regarding the side sills. This adjustability helps prevent the body from rattling by allowing the user to set the width relative to the wheels. Practical Uses They serve as a tuning component for SCX10 Jeep Cherokee models to improve body fitment and reduce unwanted movement or noise during operation. Included Parts - Rockslider Links SCX10.stl - Rockslider Rechts SCX10.stl Assembly Guidance The sliders are designed to utilize the original screw mounting points for installation.

Tecnología
Sin probar
Material
—
Dificultad
Sin especificar
Vista de Axial SCX10 Shock Seals Replacement Spacers

Axial SCX10 Shock Seals Replacement Spacers

Axial SCX10 Shock Seals Purpose These replacement spacers are designed to address oil leakage issues in factory Axial SCX10 shocks. By replacing the original 1mm spacers with these 1.4mm versions, the additional thickness provides extra compression on the O-rings when the bottom cap is tightened, creating a tighter seal without affecting damping behavior. Practical Uses This modification is intended for RC crawler enthusiasts looking to prevent oil from escaping their SCX10 factory shocks. The increased thickness aims to provide a more reliable seal over long-term use. Included Parts - Shock Spacer AXI233002 replacement (.stl) - OpenSCAD source code (.scad) for tolerance adjustments Printing and Assembly Guidance For printing, the creator used a Prusa MK4 with a 0.4mm nozzle and PET-G material. It is recommended to use a 0.10mm layer height to ensure a smooth perimeter. Users should print a single test piece to verify that the outer diameter matches the original injection-molded spacers and that the thickness is exactly 1.40mm. The inner diameter can be slightly smaller as long as the shock shaft glides smoothly. To assemble, rebuild the shocks according to the manual, replacing the original spacers between the O-rings with these printed parts. Apply shock lubricant liberally around the O-rings. The bottom shock cap may feel slightly tighter than before due to the increased spacer thickness.

Tecnología
Sin probar
Material
—
Dificultad
Sin especificar