Upgrades for "A6M2 Zero" by 3DLabPrint
Functional upgrades for the A6M2 Zero model aircraft. Battery Protector: Designed to prevent the battery from hitting the motor's shaft during a collision by providing a flat, wide area between the battery and the motor. The author reports it was tested in two crashes and works well. The author recommends using regular slicing, not the thin wall method. The author lists PETG as the material. Battery Holder: Designed to replace the stock opening for velcro. The author states the stock opening is unusable and that pausing the print to install velcro compromises fuselage strength. This element is intended to be put in place of the default one which must be cut away with a knife. The author recommends using regular slicing, not the thin wall method. The author lists PLA/PETG as the material. Servo Protector: Designed to protect the servo arm from hitting the ground during belly landings. The author suggests gluing this part in place with sticky tape rather than CA glue, as it may need periodic replacement. The author states: "Important: Use 3DLabPrint’s thin wall slicing method to slice this part!". The author lists LW-PLA as the material. Files: - battery-protector.3mf - A6M2 Batter Holder.3mf - A6M2-servo-protector.3mf
- Technology
- Sin probar
- material
- —
- Difficulty
- Sin especificar