Traxxas 2wd Wheelie Bar
Traxxas 2wd Wheelie Bar Purpose This is a fully printable wheelie bar designed for Traxxas 1/10 scale 2wd cars and trucks. It is intended to provide a 35-45 degree angle depending on the specific vehicle, while remaining tucked closer to the body. Practical Uses This model is compatible with RPM and Stock bumper mounts for vehicles including the Traxxas Bandit, Rustler, Stampede, and Slash. It is designed to be a replaceable part that can be reprinted if worn down or broken during use. Included Parts - wheelie center bar.stl - Side Bracket.obj - Wheelie Bar.3mf - Wheel.stl Printing and Assembly Guidance For printing, the creator used PETG with a layer height of 0.15mm to 0.20mm, 6 sides, 70% infill, and supports generated from the print bed only. Assembly requires six 3mm screws. It is recommended to use screws between 15mm and 20mm long, though 10mm screws can be used if necessary.
- Tecnología
- Sin probar
- Material
- —
- Dificultad
- Sin especificar