2 modelos etiquetados

#1:10 RC

Descubre modelos 3D etiquetados como 1:10 RC y revisa sus datos de impresión, archivos y condiciones de uso antes de descargarlos.Open all filters →

RC & MecánicaGratis

Circular-Base Display Stand for 1:10 RC Crawlers - STL and 3MF

Support an RC crawler on a dedicated stand for display or workbench access. The assembled reference shows a circular base, a central upright with reinforcing fins and an upper cross frame with two broad shaped supports. The source folder labels the project for 1:10 RGT crawlers and describes it as height adjustable. Specific vehicle fit and adjustment range have not been verified by MESHOPIA. Three files are included: a lower stand part in STL, an upper stand part in STL, and a 3MF stand project. They have been renamed in English while retaining their original contents. Inspect the upper and lower interfaces before assembly and review the 3MF layout in compatible slicing software. The 3MF is an additional project file, rather than a third separately named STL component. Compare the support shape and spacing with your crawler chassis. Choose print material, orientation, walls and supports after checking the model in your slicer. No physical stability test, rated load capacity or tested print profile is documented here. The vehicle and any additional hardware are not supplied. The new MESHOPIA cover is a local visualization based on the assembled stand reference. A different color, camera view, studio background and lighting illustrate a possible printed appearance.

Technology: Sin probar
material: —
Difficulty: Sin especificar

RC & MecánicaGratis

Textured Service Ramp for 1:10 RC Drift Cars - STL

Add a small raised wheel support to an RC display or workbench setup. The source photograph shows a pair of matching ramps with straight inclined approaches, a repeating circular surface pattern and an elevated flat section supported by an open frame. The source folder and filename label the design for 1:10 RC drift cars. One STL file is included, renamed 01-textured-rc-service-ramp.stl in English without altering the printable geometry. The two physical ramps in the reference show a possible paired setup; the file inventory does not establish two separately supplied variants. Inspect the STL layout and print additional copies as needed. No car or other track equipment is included. Compare the ramp width, surface features and elevated support with your intended tires and vehicle. Wheel fit, load capacity, traction and print settings have not been physically tested by MESHOPIA. Select material, orientation, walls and supports after reviewing the model in your slicer. No separate hardware or assembly guide is documented in this extracted set. The MESHOPIA cover is a studio render of the actual STL geometry, showing one ramp with its circular surface features, recessed rear platform and open supports. The supplied geometry is unchanged; the new finish, lighting and background are part of the visualization.

Technology: Sin probar
material: —
Difficulty: Sin especificar