Model information
Description
Traxxas 2wd Wheelie Bar
Purpose
This is a fully printable wheelie bar designed for Traxxas 1/10 scale 2wd cars and trucks. It is intended to provide a 35-45 degree angle depending on the specific vehicle, while remaining tucked closer to the body.
Practical Uses
This model is compatible with RPM and Stock bumper mounts for vehicles including the Traxxas Bandit, Rustler, Stampede, and Slash. It is designed to be a replaceable part that can be reprinted if worn down or broken during use.
Included Parts
- wheelie center bar.stl
- Side Bracket.obj
- Wheelie Bar.3mf
- Wheel.stl
Printing and Assembly Guidance
For printing, the creator used PETG with a layer height of 0.15mm to 0.20mm, 6 sides, 70% infill, and supports generated from the print bed only. Assembly requires six 3mm screws. It is recommended to use screws between 15mm and 20mm long, though 10mm screws can be used if necessary.
Original text by the author on Printables
<p>This is a fully printable wheelie bar that fits RPM and Stock bumper mounts for Traxxas 1/10 scale 2wd Cars and Trucks including the Bandit, Rustler, Stampede and the Slash. </p><p>I have printed it in PETG at 0.15 and 0.20 layer height at 6 sides and 70% infill and supports from the print bed only. They take quite a bit of abuse from multiple vehicles in my household and in a pinch it's easy enough to print another one out as they wear down or get broken. The angle is just enough to get about 35-45 degree angle depending on the car but also being tucked in closer to the body.</p><p>Requires six 3mm screws and nothing else to assemble, I recommend at least 15mm - 20mm long screws but 10mm long will do if that's all you have.</p><p> </p>
Questions and contributions