This organizer allows for placing fine tools, small connectors, or workpieces in separate compartments and orienting the assembly to the most comfortable position. The rectangular body rotates between the triangular arms of a wide base and is immobilized by two printed screws, one on each side. A single interchangeable divider is installed inside the body: the available variants create 6, 8, 10, 12, 14, 16, or 27 cells, allowing the layout to be adapted to the diameter and quantity of the objects to be organized.

The official source was updated after the initial import. The author added a main body and two new screws to correct the thread direction, which had been reversed on one side when mirroring the original design. For a new assembly, use Main_Body_Updated.stl, Screw_1_Updated.stl, and Screw_2_Updated.stl along with Main_Stand.stl and only one of the dividers. The previous files are kept as part of the CC0 publication, but they are not the recommended reference. Optional_2nd_Body_print_if_needed.stl is an optional part and is not part of the basic five-piece set.

Printing is intended for FDM without supports. The support is placed flat on its base, the body rests on its back face, and the screws are oriented on their top face, following the author's instructions. As a starting point, use a 0.4 mm nozzle, 0.20 mm layers, between three and four perimeters, and a 15% gyroid infill. PLA is sufficient for desktop use; PETG provides more toughness to the arms and the threads, while ABS can be used if a closed printer and a stable configuration are available. The threads require a well-calibrated first layer and a prudent dimensional compensation.

Before assembly, remove strings or burrs from the pivots, the side housings, and the threads. Place the updated body between the arms of the stand, insert each updated screw into its corresponding side, and rotate them without forcing. Adjust the tilt and tighten only until the body is immobilized. Then place a divider inside the body and check that it sits without deforming it. If the thread offers abnormal resistance, do not use pliers or increase the torque: check orientation, tolerance, and screw selection.

Stability depends on the surface, the tilt, and the load distribution. Place the heaviest objects near the center and do not use the organizer as a handle, structural support, or base for equipment. The cells do not have a universal measurement for all pens, cables, or tools; it is advisable to compare the actual dimensions with the chosen divider. The part does not include electrical insulation, protection against liquids, or certification for industrial environments.

The 21 current geometric files were verified: 15 STL and 6 STEP. All STLs have finite coordinates, zero degenerate triangles, a watertight mesh, and consistent orientation; the STEP files feature an ISO-10303-21 header and do not include external references. No G-code, images, PDFs, or machine files were found in the current official source. The new cover was generated exclusively from a technical render of the updated five-piece set assembled with the 27-cell divider.