MESHOPIAModel sheet · for your workshop
RC & Robotics
Traxxas 2wd Wheelie Bar
Authorship, licence & source
- Original author
- Tobashadow
- Publishing account
- Meshopia
- Licence
- CC0 · Public domain · Full terms
- Availability
- Free package hosted by MESHOPIA
- Listed contents
- 4 files · STL · OBJ · 3MF
- Declared source
- Printables
- Source link
- https://www.printables.com/model/544173
Read the licence terms on the original listing. This sheet does not replace those terms or grant file access or additional rights.
Project documentation
- Assembly manual
- Not identified in the file list
- Bill of materials
- Not identified in the file list
Grouped by filename, without inspecting contents. Links lead to the public model listing; this sheet does not include the documents or grant access to paid downloads.
Before making: confirm additional parts, electronics, tools, scale and mounting points with the creator. A bill of materials does not establish that the assembly has been built or tested.
Print preparation
- Print status
- Not verified
Scale modelling & compatibility
- Scales
- 1:10
Scales and compatibility are as published. Rescaling can change tolerances, fit and hardware requirements.
Published description
Traxxas 2wd Wheelie Bar
Purpose
This is a fully printable wheelie bar designed for Traxxas 1/10 scale 2wd cars and trucks. It is intended to provide a 35-45 degree angle depending on the specific vehicle, while remaining tucked closer to the body.
Practical Uses
This model is compatible with RPM and Stock bumper mounts for vehicles including the Traxxas Bandit, Rustler, Stampede, and Slash. It is designed to be a replaceable part that can be reprinted if worn down or broken during use.
Included Parts
- wheelie center bar.stl
- Side Bracket.obj
- Wheelie Bar.3mf
- Wheel.stl
Printing and Assembly Guidance
For printing, the creator used PETG with a layer height of 0.15mm to 0.20mm, 6 sides, 70% infill, and supports generated from the print bed only. Assembly requires six 3mm screws. It is recommended to use screws between 15mm and 20mm long, though 10mm screws can be used if necessary.
Declared changes from the original
AI-assisted English description reviewed against the CC0 source. Original content and author attribution retained; photographs from the author's Printables model gallery.