Model information
Description
A fully printable wheelie bar that fits RPM and Stock bumper mounts for Traxxas 1/10 scale 2wd cars and trucks, including the Bandit, Rustler, Stampede, and the Slash. The author reports printing it in PETG at 0.15 and 0.20 layer height with 6 sides and 70% infill, using supports from the print bed only. The author notes the angle provides approximately 35-45 degrees depending on the car and is tucked closer to the body. Assembly requires six 3mm screws; the author recommends at least 15mm - 20mm long screws, though 10mm long screws will work.
Original text by the author on Printables
<p>This is a fully printable wheelie bar that fits RPM and Stock bumper mounts for Traxxas 1/10 scale 2wd Cars and Trucks including the Bandit, Rustler, Stampede and the Slash. </p><p>I have printed it in PETG at 0.15 and 0.20 layer height at 6 sides and 70% infill and supports from the print bed only. They take quite a bit of abuse from multiple vehicles in my household and in a pinch it's easy enough to print another one out as they wear down or get broken. The angle is just enough to get about 35-45 degree angle depending on the car but also being tucked in closer to the body.</p><p>Requires six 3mm screws and nothing else to assemble, I recommend at least 15mm - 20mm long screws but 10mm long will do if that's all you have.</p><p> </p>
There are no comments yet. Verified ratings and makes appear separately below.