MESHOPIAFicha del modelo · para tu taller
Other Printer Parts & Upgrades
QIDI X-Max 3 X-Plus 3 CR Touch Bracket
Autoría, licencia y procedencia
- Autor original
- Levi Elliott
- Cuenta publicadora
- Meshopia
- Licencia
- CC0 · Dominio público · Texto completo
- Disponibilidad
- Paquete gratuito alojado en MESHOPIA
- Contenido anunciado
- 1 archivo · STL
- Fuente declarada
- Printables
- Enlace de procedencia
- https://www.printables.com/model/1107431
Consulta las condiciones de la licencia en la ficha original. Esta hoja no sustituye su texto ni concede acceso a archivos o derechos adicionales.
Documentación para tu proyecto
- Manual de montaje
- No identificado en el listado
- Lista de componentes
- No identificado en el listado
Agrupación por nombre de archivo, sin comprobar su contenido. Los enlaces llevan al listado público del modelo; esta hoja no incluye los documentos ni concede acceso a descargas de pago.
Antes de fabricar: confirma componentes adicionales, electrónica, herramientas, escala y puntos de montaje con el autor. Una lista de componentes no acredita que el conjunto haya sido montado o probado.
Preparación de impresión
- Estado de impresión
- No comprobado
Descripción publicada
QIDI X-Max 3 X-Plus 3 CR Touch Bracket
Purpose
This model is a mounting bracket designed to house a CR Touch probe on the QIDI X-Max 3 and X-Plus 3 printers. It serves as a replacement or modification housing for the probe and its associated electronics.
Practical Uses
It is used to integrate a CR Touch sensor into the printer setup. Users may need to modify the board layout or configuration settings in Klipper (printer.cfg) to accommodate the sensor. Note that the CR Touch wiring differs from a BL Touch; the extruder board typically utilizes a 2-pin plug (Red/Ground, Blue/Signal) and a 3-pin plug (Black/5V, White/Ground, Yellow/Pin control).
Included Parts
- CR Touch Bracket.stl
Printing and Assembly Guidance
Assembly requires removing the CR Touch components from the original cover. The case halves are held together by two clips on each side, and the board is held by one clip on each side. Users should be careful with the small internal wires. It is suggested to use a very small drop of epoxy on the board and probe case to secure them, ensuring the pin is aligned with the sensor's U-shape. Due to potential fitment issues with certain materials, the user reported needing to manually bore out the hole with a 13/32 drill bit and remove some material for the board to fit. While glass-filled nylon was used, PETG may provide more accurate dimensions due to less surface roughness.
Cambios declarados respecto al original
AI-assisted English description reviewed against the CC0 source. Original content and author attribution retained; photographs from the author's Printables model gallery.