Satsana Ender 3 Fan Duct for CR-Touch
A modified remix of the Satsana Fan Shroud/Duct by eric-anastas for the Ender 3 Pro. This shroud is modified to fit with the Creality CR-Touch touch sensor, using the standard hardware that comes with it. Printing instructions: Take note of the printing picture above. You will need to use a block object to prevent support generation on overlap, so that the bottom connecting sections will be supported only. The author printed this at .16 layer height, but notes that .2 may work. Author's reported print settings: Printer Brand: Creality Printer: Ender 3 Pro Rafts: No Supports: Yes Resolution: 200 Infill: 38 Filament: Overture PLA Post-Printing instructions: Use an exacto blade or razor to remove the supports from the connecting sections to allow room for the Cr-Touch bracket to install properly.
- Technology
- Sin probar
- material
- —
- Difficulty
- Sin especificar