Meshopia · EnglishEnglish
MESHOPIA

4 modelos etiquetados

#rccar

Descubre modelos 3D etiquetados como rccar y revisa sus datos de impresión, archivos y condiciones de uso antes de descargarlos.Open all filters →
Vista de Extensor de postes de carrocería para Corally Syncro RC

Body post extender for Corally Syncro RC

Extender for the posts that hold the body of an RC car, specifically designed for Corally Syncro. The author developed it while installing two hard-case LiPo batteries in a Syncro 4: the height of the batteries and cables prevented the rear of the body from being correctly positioned. Potential adaptation to other cars requires measuring the post and the fastening. Preparation, compatibility, and printing Check the post diameter, its usable length, and the body retention system. Ensure that the additional height does not leave cables compressed or create excessive gaps. The source does not specify material or printing parameters. Print a fit test before manufacturing the final set and verify that the body remains secured during the suspension travel.

Technology
Sin probar
material
—
Difficulty
Sin especificar
Vista de Soporte de luces MEUS para Traxxas UDR

MEUS light bracket for Traxxas UDR

Bracket designed to mount MEUS Racing RC LED lights on a Traxxas UDR. It allows adapting this accessory to the vehicle, but the download corresponds only to the printable part: it does not include lights, wiring, or hardware. The source does not identify all the light variants that might fit. Preparation, compatibility, and printing The author recommends PETG and 100% infill. Keep these details as a reference for their proposal and check the geometry and mounting points with your equipment. Leave enough clearance for the wiring and ensure it is not pinched by the bodywork. After printing, check the holes without forcing the layers and align the assembly before final tightening.

Technology
Sin probar
material
PETG
Difficulty
Sin especificar
Vista de Terminal de amortiguador para Arrma Mojave Grom · ARA-1495

Shock absorber end for Arrma Mojave Grom · ARA-1495

Printable replacement for the Arrma Mojave Grom shock rod end, identified in the title as M2.5. The author created it due to the lack of a spare part and describes it as a provisional solution inferior to the original piece. The commercial reference provided is ARA-1495. Preparation, compatibility, and printing Check the thread, ball joint, and travel before use. Do not force the rod if the print does not accurately reproduce the housing. The source does not provide a profile or durability tests; it must not be presented as an upgrade for the shock absorber. Inspect the end in initial tests and replace any print with cracks or excessive play.

Technology
Sin probar
material
—
Difficulty
Sin especificar
Vista de Separadores de llanta para DKS Pro de DukeDoks

Wheel spacers for DukeDoks DKS Pro

Spacers designed to prevent certain commercial wheels from rubbing against the suspension arms of the DukeDoks DKS Pro. The source offers thicknesses of 1, 2, 3, 4, and 5.5 mm. The fit depends on the wheel, the tire, and the actual configuration; adding spacing also modifies the wheel's position relative to the axle. Preparation, compatibility, and printing The author relates 1 mm to M3 × 16 screw, 2 and 3 mm to M3 × 18, 4 mm to M3 × 20, and 5.5 mm to M3 × 25. Check that the chosen length reaches the nut without bottoming out. Use PLA and perimeters until the section is filled. Before riding, rotate and articulate each wheel to confirm that the rubbing disappears without creating another point of contact.

Technology
Sin probar
material
—
Difficulty
Sin especificar