Give an RC car a wide rear-wing profile using the supplied printable spoiler. The geometry has an angular open-frame center, raised end sections, reinforcing surfaces and two mounting tabs with openings. The source photograph shows the wing installed on an off-road RC car; the vehicle, tires and separate mounting support shown there are not included.
One STL file is supplied, renamed 01-open-frame-rear-wing.stl in English without altering its geometry. The original filename contains 2MM and TPU labels. These are source labels, rather than a verified thickness measurement or a tested material recommendation. No vehicle scale or specific model compatibility is established by the supplied inventory.
Inspect the wing and mounting-tab spacing in your slicer and compare them with your intended RC vehicle before printing. Choose material, orientation and supports to suit the actual geometry. Aerodynamic performance, impact resistance, physical fit and print settings have not been tested by MESHOPIA. No fasteners or assembly instructions are separately included.
The current cover is an original AI-assisted MESHOPIA photorealistic illustration of the supplied model or its components in a hobby-workshop use or finishing scene. It illustrates a proposed finish and does not document a manufactured, printed, assembled or tested prototype. Consult the downloadable source files for the geometry and included components.
- Tecnología
- Sin probar
- Material
- —
- Dificultad
- Sin especificar
