Klipper configuration for CR-10
The author provides configuration files for Klipper and FLUID used on a modified CR-10. The author's reported modifications to the CR-10 include a dual gear red extruder, a PEI bendable bed, and an all-metal hot-end clone. The setup uses a Raspberry Pi 3B connected via pin21 to a relay for power control. The author notes that with well-configured pressure advance, input shaper may not be necessary, though omitting it may reduce print time by 20% due to fewer movements. The author reports that the CR-10 can run at 2000mm/sec² acceleration and 100mm/sec printing speed with good quality, provided the filament temperature is increased by 10°C. The author personally prints at 1000mm/sec² acceleration and a maximum speed of 80mm/s. The author mentions that using a lighter bed instead of the original glass may allow for higher speeds.
- Technology
- Sin probar
- material
- —
- Difficulty
- Sin especificar