Twin-Intake Trainer Jet - Complete Airframe and Printable Kit
OVERVIEW This twin-intake trainer-jet project includes a complete-airframe display representation, separate printable parts and editable slicer projects. It is a land-based aircraft model, not an amphibious aircraft. The original technical manual identifies the design as a T-2A Buckeye EDF project. Source geometry remains recognizable despite neutral public filenames; the publishing account does not claim original design authorship. CONTENTS AND VARIANTS The retained technical collection contains 53 distinct 3MF projects, 61 distinct STL files and a 27-page illustrated assembly manual. Duplicate source-folder slots are documented privately rather than mistaken for additional design variants. The complete-airframe STL is a reference representation; it does not replace the separate building parts or establish that the aircraft can be printed as one solid piece. All supplied geometry variants and project parameters remain available. NATIVE PROJECT PRESERVATION The 3MF projects include embedded meshes and PrusaSlicer configuration. Geometry arrays, faces, materials, build transforms, instance counts and bounds were independently compared after reopening with a second 3MF reader. Original printing settings and custom G-code are retained byte for byte; this is preservation, not validation for your printer. Optional source-file labels refer to embedded mesh provenance, including some source filenames not supplied separately. They are not missing external OPC model resources. Review settings in a compatible slicer before use; no G-code was executed or sent to a printer. SCALE AND DIMENSIONS The source manual states 1:10 scale, a 45.75-inch wingspan and a 46.4-inch length. These are source declarations, not dimensions physically verified by this publishing account. The complete-airframe geometry and individual project layouts may have different transforms or preparation contexts. Confirm units and measure a known feature in your slicer, then cross-check another dimension before scaling all mating parts together. Display normalization must not be used as a manufacturing dimension. ASSEMBLY DOCUMENTATION The original illustrated manual retains its technical names, credits, diagrams and operating notices. It describes fuselage sections, wing and tail joins, alignment pins, hatches, fan installation, control surfaces and optional landing-gear hardware. Its earlier finished-aircraft photographs are source references, not a newly documented print by this account. Read the entire manual before planning materials, tools or hardware, and dry-fit the joints before bonding. PRINT PREPARATION - UNTESTED The source project discusses LW-PLA and printer-specific preparation. Those settings are not universal recommendations. Inspect wall thickness, hollow sections, mesh condition, thin edges, control clearances, hatch fit and connection surfaces. Check each part against your build volume and nozzle capability. Test a representative joint and thin section before committing to the whole aircraft. Existing custom start/end G-code and machine identifiers must be checked against your own firmware and printer; retaining them does not certify compatibility. HARDWARE AND FINISH The source documentation describes an 80 mm electric ducted fan and additional hardware. No fan, battery, electronics, retracts, fasteners, tubes or tools are supplied as physical goods. Hardware suitability, balance, structural strength and flight performance have not been tested by this publishing account. Paint and adhesive can change clearance, mass and balance. Use thin finish coats and recheck joints after finishing. A rendered display does not demonstrate airworthiness or a successful physical build. RIGHTS AND TRANSPARENCY Files are offered free under CC0 according to the uploader’s express redistribution authorization. Necessary technical identifiers and legitimate source credits remain. Opaque filenames do not make the original geometry anonymous. Preserve the source documents for technical context and assess their applicability to your own equipment. No physical print or flight certification is implied. #TrainerJet #AircraftModel #EDF #ModelKit #ScaleModel #LWPLA #3MF #STL #3DPrinting #CC0 IMAGE DISCLOSURE Local PC ComfyUI/Qwen generated the workshop surroundings. The painted source-model render and original display base were protected in the final composite. The public lightweight 3D view is a simplified technical display; full STL and project files remain in the download.
- Tecnología
- Sin probar
- Material
- —
- Dificultad
- Sin especificar