Información del modelo
Descripción
XRC RC-2 Rear Suspension Top Arm Inner L/R (Part no. 613007/XRC.613007)
Purpose
This model is a 3D printable replacement for the XRC RC-2S Rear Suspension Top Arm Inner (Left/Right). Note that this is not an exact 1-to-1 dimensionally accurate reproduction; it has been designed to be thicker and chunkier than the original part to accommodate 3D printing.
Practical Uses
It serves as a replacement component for R/C vehicles using the XRC RC-2S chassis. Because the part is designed to be thicker than the original, the original brass spacer is not required for installation.
Included Parts
Two distinct versions are available for download:
1. Printed Threads version
2. Threaded Inserts version
Printing and Assembly Guidance
Assembly requirements depend on the chosen version:
For the Printed Threads version: Requires one M5 bolt (30mm or 35mm long) per part. The author notes that 30mm bolts are slightly short and 35mm bolts are slightly long and protrude from the part, but either should function.
For the Threaded Inserts version: Requires one M5x10x7 (10mm long, 7mm Outer Diameter) threaded insert, one M8x8x10 or M8x10x10 (8mm or 10mm long, 10mm Outer Diameter) threaded insert, and one M5 bolt (30mm or 35mm long) per part.
Texto original del autor en Printables
<p>This is a 3d printable replacement for the xrc rc-2s Rear Suspension Top Arm Inner L/R - (Part no. 613007/XRC.613007.) This isn't an exact 1 to 1 dimensionally accurate reproduction of the original part, this has been designed to be thicker since it's printed. You also don't need the old brass spacer from the original parts, that side was also made thicker/chunkier than the original.</p><p>There are 2 versions of this model, one with printed threads and another sized to take brass threaded inserts.</p><p>For the printed threads version, you only need one m5 by 30mm or 35mm long bolt for each one you print. (30's a tiny bit short, 35's a tiny bit longer and pretrudes from the part. Either length should work fine.)</p><p>For the threaded inserts version you'll need one M5x10x7 (10mm long, 7mm Outer Diameter,) one M8x8x10/M8x10x10 (8mm or 10mm long, 10mm Outer Diameter) threaded inserts and one M5 by 30mm or 35mm long bolt for each one you print.</p><p><i>EDITS</i><br>05/10/24 added print photos</p><p>Category: R/C Vehicles</p>
Preguntas y aportaciones