MESHOPIAModel sheet · for your workshop
RC & Robotics
XRC RC-2 Rear Suspension Top Arm Inner L/R (Part no. 613007/XRC.613007) 3D Printable Replacement
Authorship, licence & source
- Original author
- deagon
- Publishing account
- Meshopia
- Licence
- CC0 · Public domain · Full terms
- Availability
- Free package hosted by MESHOPIA
- Listed contents
- 2 files · STL
- Declared source
- Printables
- Source link
- https://www.printables.com/model/1022701
Read the licence terms on the original listing. This sheet does not replace those terms or grant file access or additional rights.
Project documentation
- Assembly manual
- Not identified in the file list
- Bill of materials
- Not identified in the file list
Grouped by filename, without inspecting contents. Links lead to the public model listing; this sheet does not include the documents or grant access to paid downloads.
Before making: confirm additional parts, electronics, tools, scale and mounting points with the creator. A bill of materials does not establish that the assembly has been built or tested.
Print preparation
- Print status
- Not verified
Scale modelling & compatibility
- Project type
- Functional RC
- Part type
- Axles / Suspension / Steering
Scales and compatibility are as published. Rescaling can change tolerances, fit and hardware requirements.
Published description
XRC RC-2 Rear Suspension Top Arm Inner L/R (Part no. 613007/XRC.613007)
Purpose
This model is a 3D printable replacement for the XRC RC-2S Rear Suspension Top Arm Inner (Left/Right). Note that this is not an exact 1-to-1 dimensionally accurate reproduction; it has been designed to be thicker and chunkier than the original part to accommodate 3D printing.
Practical Uses
It serves as a replacement component for R/C vehicles using the XRC RC-2S chassis. Because the part is designed to be thicker than the original, the original brass spacer is not required for installation.
Included Parts
Two distinct versions are available for download:
1. Printed Threads version
2. Threaded Inserts version
Printing and Assembly Guidance
Assembly requirements depend on the chosen version:
For the Printed Threads version: Requires one M5 bolt (30mm or 35mm long) per part. The author notes that 30mm bolts are slightly short and 35mm bolts are slightly long and protrude from the part, but either should function.
For the Threaded Inserts version: Requires one M5x10x7 (10mm long, 7mm Outer Diameter) threaded insert, one M8x8x10 or M8x10x10 (8mm or 10mm long, 10mm Outer Diameter) threaded insert, and one M5 bolt (30mm or 35mm long) per part.
Declared changes from the original
AI-assisted English description reviewed against the CC0 source. Original content and author attribution retained; photographs from the author's Printables model gallery.