Accessory placed over an Xbox controller stick to use it as a lever in a drone simulator. Its function is to modify the grip of the controller during the simulation; it does not convert the controller into a radio control transmitter nor does it add direct communication with a drone. The source does not identify all compatible controller revisions.
Preparation, compatibility, and printing
The author specifies PLA and supports. Compare the housing with your controller's stick and check that the accessory does not press buttons or limit the range of motion. Carefully remove the supports in the engagement areas. Start with a fit test without forcing the stick; then configure sensitivity and calibration within the simulator.
Original text by the author on Printables
print in PLA with support,
it is a conversion that goes on the thumbsticks so that you can use an xbox controller with a drone simulator
The publishing account has not yet confirmed any print settings. Material, supports, difficulty, temperatures and times remain as "Not verified" until verifiable data is available.
Conversation and organization
Save it with context.
Collections are used to organize projects; comments, to ask or provide information without converting it into an evaluation.
There are no comments yet. Verified ratings and makes appear separately below.
Community Evidence
Checking real impressions…
Before downloading
License
§
CC0 · Public domain
The author waives their rights to the extent permitted by law. Copying, modifying and reusing the work are permitted, including for commercial purposes.
✓ Share✓ Modify✓ Commercial use
Consult the full license ↗This summary facilitates reading and does not replace the legal conditions declared in the model sheet.
There are no comments yet. Verified ratings and makes appear separately below.