<p>Because I wanted to have my X-Sense RC01 remote in an accessible location where I can easily grab it, I created this holder for it. It has a little indentation on the back to fit some double sided tape (my tape is 1.0mm thick, so I made the indentation 0.6mm deep).</p><p>The remote fits inside the holder very easily. I didn't want to make it too snug, because I wanted to prevent a hassle with getting it out in case of an emergency. You can scale down a few ticks on the depth axis if you think the holder should be more snug.</p><p>I was actually aiming for the little circular cutouts at the top to align with the round button on the remote, but I guess I made a mistake with my measurements because they don't align properly. For me it didn't warrant another print, so I left it like this (and in the files uploaded here). In case you want to fix that, I've also uploaded the step files.</p><p>The holder in the image was printed on a Bambu Lab P1S with a .16mm profile, and FormFutura rPLA White filament. The orientation was upright, no support needed. The 3MF I used to print it with is uploaded here as well.</p>