<p>While the Extreme Beast RC car has plenty of power, the stock steering setup can feel a bit loose and imprecise. I designed this custom steering mechanism to fix the tolerances and focus on handling rather than just raw speed.</p><p><strong>Important Note on the Design:</strong> Unlike the stock component, I designed this with a specific <strong>3.2 mm opening to act as a clip-on part</strong>. You don't need to struggle with the stock mounting method — this custom part simply clips securely right into place!<br><br><strong>Key improvements:</strong></p><ul><li><p><strong>Clip-On Installation:</strong> Features a custom 3.2 mm opening (not found on the stock part) that allows the mechanism to securely clip onto the assembly.</p></li><li><p><strong>Optimized Tolerances:</strong> Increased the internal diameter by 0.1 mm to prevent binding while maintaining a snug, precise fit.</p></li><li><p><strong>Better Handling:</strong> Significantly improves grip and directional control at higher speeds by eliminating steering slop.</p></li></ul><p><strong>Files included:</strong></p><ul><li><p><code>.stl</code> for direct printing.</p></li><li><p><code>.step</code> file included if you want to remix or adjust the tolerances for your specific setup!</p></li></ul><p><strong>Print Settings:</strong></p><ul><li><p><strong>Material:</strong> PLA is perfectly fine for testing and standard use, but consider PETG if you drive your RC car aggressively or in hot weather.</p></li><li><p><strong>Infill:</strong> 40-60% (Gyroid or Cubic recommended for mechanical strength).</p></li><li><p><strong>Perimeters (Walls):</strong> 3 or 4 perimeters for extra durability around the screw holes and stress points.</p></li><li><p><strong>Supports:</strong>&nbsp;Yes</p></li></ul><p></p>