Add a twin-exhaust visual detail to a suitable MST E30 RC drift-car body. The supplied photograph shows the accessory beneath the rear bodywork. Inspection of the actual STL shows a rounded muffler housing, two curved outlet tubes with open ends, and an angular mounting bracket with reinforcing ribs. This is a decorative RC body accessory.

One STL is included, renamed 01-e30-twin-outlet-muffler.stl without changing its geometry. The model contains the muffler and its integrated mounting form. The vehicle, body shell and attachment hardware shown or implied by the reference are not included. No scale is independently established by the supplied folder or filename.

Compare the mounting bracket and outlet clearance with your intended body before printing. Compatibility beyond the source MST E30 label, mounting method and physical fit have not been tested by MESHOPIA. Choose material, orientation and supports after inspecting the hollow outlets and bracket in your slicer.

The new MESHOPIA cover is a studio render of the actual STL from a new angle on a pale stone surface, with a gray finish. It retains both open outlets and the original mounting geometry.