Model information
Description
A small design produced to test the mechanical performance of FDM 3D printing. The author tested this model on a 1/8 scale RC vehicle, mounted on the center differential of a Jammin X1 crt truggy. The author reports positive results, stating the part held up to rotation speeds of 30,000 rpm. Use two 2.5mm x 4 screws for the clamping collar.
3D printing parameters provided by the author:
- Material used: PLA+ and PC-GF
- Layer height: 0.16
- Line width: 0.4
- Use supports.
Original text by the author on Printables
<p>Petite conception que j'ai produite afin de tester la performance mécanique des impressions 3D fdm.</p><p>J'ai imprimé ce modèle et je l'ai éprouvé en réalité à bord d'un véhicule RC téléguidé à échelle 1/8.</p><p>Il as été monté sur le différentiel centrale d'un truggy Jammin X1 crt. Les résultats se sont avérés positifs. La pièce à tenue le coup et ce jusqu'à une vitesse de rotation de 30 000 rpm. Impressionnant!</p><p>Utiliser 2 vis 2.5mm x 4 pour le colier de serrage.</p><p><a href="https://youtu.be/t7KABk0zx2c">https://youtu.be/t7KABk0zx2c</a></p><p><strong>PARAMÈTRES D’IMPRESSION 3D</strong></p><p>Je l'ai fabriqué avec du PLA+ et du PC-GF<br>Épaisseur de couche à 0.16<br>Largeur de ligne a 0.4<br>Utiliser les supports.</p><p> </p><p> </p><p> </p>
There are no comments yet. Verified ratings and makes appear separately below.