The author recommends printing with a 0.12 layer height and a 0.4 nozzle or smaller. The author used 6 top and bottom layers, 6 walls, and 35% cubic infill. The author states that PLA works, but nylon would be ideal. The author advises to run slow at the start and use some oil or grease. The hole pattern is for a Tamiya TT-02 Chassis drive shaft, but the author notes it may fit other builds.
Original text by the author on Printables
<p>Recommend to print with .12 layer height and a .4 nozzle or smaller, I did 6 layers top and bottom and 6 walls, with 35% cubic infill. PLA works, but nylon would be ideal. Be sure to run slow at the start and use some oil or grease.</p><p>The hole pattern is for a Tamiya TT-02 Chassis drive shaft, but it may fit other builds. Someone more knowledgeable can probably comment on that.</p>
AI-assisted English description reviewed against the CC0 source. Original content and author attribution retained; photographs from the author's Printables model gallery.
The publishing account has not yet confirmed any print settings. Material, supports, difficulty, temperatures and times remain as "Not verified" until verifiable data is available.
Conversation and organization
Save it with context.
Collections are used to organize projects; comments, to ask or provide information without converting it into an evaluation.
There are no comments yet. Verified ratings and makes appear separately below.
Community Evidence
Checking real impressions…
Before downloading
License
§
CC0 · Public domain
The author waives their rights to the extent permitted by law. Copying, modifying and reusing the work are permitted, including for commercial purposes.
✓ Share✓ Modify✓ Commercial use
Consult the full license ↗This summary facilitates reading and does not replace the legal conditions declared in the model sheet.
There are no comments yet. Verified ratings and makes appear separately below.