Información del modelo
Descripción
Purpose
This is a slip-in mount designed for the Spektrum AR637T receiver. It allows dual antennas to be routed through one of four holes each to achieve a required 90-degree angle between them.
Practical Uses
The holes are sized for PTFE tubing. The author suggests that adding 0.2 mm to the tubing diameter when adjusting hole sizes provides a good fit.
Included Parts
- Spektrum AR637T RC Rcvr Antenna Mount-AntennaMountBody.stl
- Spektrum AR637T RC Rcvr Antenna Mount.fcstd
Printing and Assembly Guidance
The author printed this using white ASA on a Bambu X1C with BambuStudio's 0.16 Optimal setting and normal support. The model should be placed with the hole end down on the build plate. Note that cleaning support material from the holes may take a few minutes.
Texto original del autor en Printables
<p>Slip in mount for the AR637T. The dual antenna can be routed to one of 4 holes each allowing you to easily achieve the require 90 degree between antennae requirement. The holes are sized for PTFE tubing.</p><p>The FreeCAD 0.21.1 model file is included so you can easily change hole size. I've found adding 0.2 mm to the tubing diameter for the holes provides a nice fit.</p><p>Printed on Bambu X1C using white ASA and BambuStudio's 0.16 Optimal setting with normal support and hole end down on build plate. Yes took a few minutes to clean out the support from the holes… ;-)</p>
Preguntas y aportaciones