<p>This is a modified remix of the Satsana Fan Shroud/Duct by eric-anastas for the Ender 3 Pro. This shroud is modified to fit with the Creality CR-Touch touch sensor, using the standard hardware that comes with it.</p>
<p>Printing:</p>
<p>Take note of the printing picture above. You will need to use a block object to prevent support generation on overlap, so that the bottom connecting sections will be supported only.</p>
<p>I printed this at .16 layer height, but im sure .2 would do just fine.</p>
<h3>Print Settings</h3>
<p><strong>Printer Brand:</strong></p>
<p>Creality</p>
<p class="detail-setting printer"><strong>Printer: </strong>
<div><p>Ender 3 Pro</p></div>
<p><strong>Rafts:</strong></p>
<p>No</p>
<p class="detail-setting supports"><strong>Supports: </strong>
<div><p>Yes</p></div>
<p><strong>Resolution:</strong></p>
<p>200</p>
<p class="detail-setting infill"><strong>Infill: </strong>
<div><p>38</p></div>
<p><strong>Filament:</strong>
Overture PLA
Post-Printing
=============</p>
<p>Post Printing - using an exacto blade or razor to remove the supports from the connecting sections seen in the image below. This will allow room for the Cr-Touch bracket to install properly.</p>
<p class="detail-image"><img src="https://cdn.thingiverse.com/assets/35/f1/8e/23/9d/remove_support.png"/></p>
</p></p></p>

Category: 3D Printer Accessories